Optik Tutorials |

Outcome:

Again create an applied image. Now go to Filter > Stylize > Extrude. Now select some settings that you think look good. Set this layer to Lighten. You shouldn’t need to lower opacity, but do so if you think it is needed.

Now make another applied image, and go to Filter > Distort > Glass. Use medium settings. Erase the bulk of this layer and set it to Lighten.

Repeat step 12 but use the Filter > Brush Strokes > Spatter instead of the glass filter. Set this layer to Lighten on 45% opacity. Erase the bulk of this layer. Now repeat this step and erase different parts.

Make yet another Applied Image. Go to Filter > Blur > Gaussian Blur. Now select 2px. Set this layer’s blending mode to Soft Light. If this over-contrasts your signature, lower the opacity, but that should now be needed. Repeat but set to lighten.

Now make an applied image. Then go to Filter > Sharpen > Sharpen. Now on a new layer add some white air brushing. This isn’t needed if you don’t know how to do it. Add a few touch up effects like a border and your done!